Pumpkin Carving

Halloween party when their children have fun no matter prepares pumpkin to enliven the party. They can be creative with spoon, serrated knife and even a small nail. They can design as simple as making eye and one tooth or more perfect than that. They can be bought in stores or even at online stores.

Material:

1. Pumpkin
2. Printer and paper
3. Spoon or scoop pumpkin
4. Small nail
5. Serrated knife

Instructions:
Prepare your pumpkin:
Make a hole on top. Cut sloping lid not to enter.
Discard the seeds and strings with a spoon
 Flesh up to 1 inch thickness estimate
Create a pattern.
Trim the paper
Tape to attach a pumpkin pattern.
If the pumpkin is quite thick, dip the paper in water or vegetable oil
Place the pattern to the pumpkin, affix with pins or masking tape and allow to dry.
The hole pattern with a nail, push pin or pumpkin poker. Make a hole 1 / 8 inch apart (or even closer to a more complicated pattern.) This step can take quite a while be patient.
Remove the paper from the pumpkin.
Rub flour or chalk dust all over the part where you puncture a hole so you can see.
Push a nail through the skin of the pumpkin where you want to start carving.
Turn around and push up all the way to the pumpkin, and remove it.
Repeat this step if you want to make the carvings (the eyes, nose, etc.).

Use a small nail you as a starting point, cut the design with a serrated knife.

Use the movement of the saw to cut your design, with very light pressure ...

When making sharp corners, remove and reinsert the preview and into the corner.

After your pumpkin is ready, use a pumpkin light (safer than candles) or a wax that is designed for pumpkin halloween.

Light the candle and place it on a piece of tinfoil inside the pumpkin. Close. Let soon

Remove the lid and smoke for a place on it


Pumpkin you've finished, good halloween ...